Connecting The Water Draining Hose To The Drain - Beko WTV9745XM User Manual

6.5 Connecting the water draining hose to the drain

• Attach the end of the drain hose directly to waste water
drain, washbasin or bathtub.
• Do not contact the discharged water. Risk of being burnt as
the water may be hot.
CAUTION!
• Fix the water drain hose end completely to prevent risk of
dislocation.
EN / 18
a) Connect the straight end of the mains inlet hose
provided with the product to the cold water tap and
the warped end to the water inlet on the back of the
product as shown in the figure.
b) Tighten all hose nuts by hand securely. Never use a
tool when tightening the nuts.
c) Open the taps completely after making the hose
connection to check for water leaks at the connection
points. If any leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after checking
the seal. Turn the tap on and repeat the checks.
d) Keep the taps closed when the product is not in use.
a) Connect the water drain hose to a minimum height of 40 cm and a
maximum height of 100 cm.
b) The product may fail if water drain hose is at or close to floor level
(under 40 cm) as it would take water in and out continuously.
c) The product may fail if water drain hose is placed higher than 100 cm
as it cannot discharge water and water stays inside the product.
Therefore, follow the heights described in the figure.
Washing Machine / User's Manual