Advertisement
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to ensure compliance.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in the USA (or where FCC rules apply); only those antennas certified with the
product are to be used. The installer should configure the output power level of antennas, according to
country regulations and per antenna type. Professional installation is required for equipment with
connectors to ensure compliance with health and safety issues.
Approved Antenna Table:
Antenna Model
UNII-1 (5150-5250 MHz) and UNII-3 (5725-5850MHz)
MT-482016/N/A
PA58-24-ANT
HDDA5W-32-DP2
UNII-2A (5250-5350 MHz) and UNII-2C (5470-
HGO-antenna-
OUT
MTAS-5G-
19D120
*The same type of antenna and lower antenna gain than those listed above in the table may also be
used in accordance with certification.
Type
Omnidirection
al
Panel
Dish
5725MHz)
Omnidirection
al
Sector
Antenna gain,
dBi
8.5
24
32
7
19
Advertisement
