Advertisement
Quick Links
Advertisement
Related Manuals for Elu TGS173
Summary of Contents for Elu TGS173
- Page 1 TGS173...
- Page 3 30 29 37 38 40 39...
- Page 5 13 14 59 57 62...
- Page 6 21 61 76 75 69 70 71 45°...
- Page 7 19 26 30 82 80 81 29 2 mm 3-8 mm...
-
Page 9: Table Of Contents
- 1 EN 55014, EN 61000-3-2 & EN 61000-3-3. EC-Declaration of conformity en - 1 For more information, please contact Elu at the address below or refer to Safety instructions en - 2 the back of the manual. Package contents... -
Page 10: Safety Instructions En
Follow the instructions for maintenance and changing General accessories. Inspect the tool cords at regular intervals and, if damaged, have them repaired by an Elu authorized repair agent. 1 Keep work area clean Inspect the extension cords periodically and replace them if damaged. -
Page 11: Package Contents En
• Never place either hand in the blade area when the saw is connected to the electrical power source. Your Elu flip-over sawing machine has been designed to operate as a mitre • Do not attempt to cut excessively small pieces. -
Page 12: Electrical Safety En
• Should your mains plug need replacing and you are competent to do For use in mitre saw mode: this, proceed as instructed below. If you are in doubt, contact an Elu authorized repair agent or a qualified electrician. • Disconnect the plug from the supply. - Page 13 E N G L I S H Assembly for mitre saw mode - Handle to the left = engaged, for use in mitre saw mode (all angles except 0-45° mitre cross cut) Mounting the under-table guard (fig. D) - Handle to the right = disengaged, for use in saw bench mode The under-table guard (48) is fitted to the top of the saw bench table.
- Page 14 E N G L I S H Checking and adjusting the 45° bevel position in mitre mode Never use your saw in saw bench mode without the upper (fig. M1 & M2) guard correctly fitted. • Ensure that the sawhead is to its extreme left-hand position with the bevel clamp handle locked.
- Page 15 E N G L I S H • To switch the machine on, press the green start button (87). Ripping (fig. V) • To switch the machine off, press the red stop button (88). • Set the blade to the correct height. •...
- Page 16 Connecting - mitre saw position • Connect one hose to the under-table guard. Take your tool to an authorized Elu repair agent where it will be disposed • Connect one hose to the small diameter outlet (11) and one to the of in an environmentally safe way.