U-Line U-3060DWRINT-00A User Manual & Service Manual page 26

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Severe Adjustment:
Note: The slides have extra
mounting holes that may be
used.
1. Loosen one slide's rear
mounting screws.
2. Remove the slide's front
mounting screws.
3. Reposition the slide so it is level.
4. Mark new front drilling holes using a different set of
mounting holes on the slide.
5. Drill the new holes with a #30 drill bit.
6. Remount the slide.
7. Repeat procedure for the other slide.
TOP-TO-BOTTOM (AND LEFT-TO-RIGHT)
ADJUSTMENT
The drawer will need a Top-to-Bottom Adjustment if, when
viewed from the front, the drawer is not level horizontally.
Viewed from the top, one side will protrude. This is caused
by one of the slides being mounted higher than the other
slide on the unit's liner.
Not Aligned
Top-to-Bottom
Front View of Unit
Mark and Drill New
Mounting Holes
Level the Slide
Not Aligned Left-to-Right
Top View of Unit
Minor Adjustment:
Note: The mounting holes on the slide are slightly larger
than the screws' diameter.
1. Loosen one slide's
mounting screws.
2. Push the slide upward or
downward to match the
position of the other slide.
3. Retighten the screws.
4. Repeat the procedure with the other slide if necessary.
Severe Adjustment:
Note: The slides have extra mounting holes that may be
used.
1. Remove one slide's
mounting screws.
2. Reposition the slide so it is
the same distance from
the bottom of the liner as
the other slide. Measure to
confirm.
3. Mark new drilling holes using different sets of mounting
holes on the slide.
Note: Front location holes are shown. Corresponding rear
holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
26
Loosen
Mounting Screws
Push Slide
Upward or
Downward
Mark and Drill New
Mounting Holes
Push Slide
Upward or
Downward
Drawers 3