Motorola Avigilon 3 Series User Manual page 48

Figure 16:
The Marvell Storage Utility Login Page
Note: If the MarvellTray icon does not open the Marvell Storage Utility, try opening
http://localhost:8845
3. In the Marvell Storage Utility page, look in the Marvell Storage Management tree to see if the Array:0
and Virtual Disk:0 icons are in the yellow alarm state. If the icons are yellow, scan the list of physical
disks in the array, to identify which disk has failed. In normal operation, the disks are labeled Physical
Disk: port 0 to Physical Disk: port 3. If one is missing, this is the disk that has failed.
You can also review the messages in the Event Log at the bottom of the Marvell Storage Utility page
to see additional information.
In the Marvell Manager, the hard drives are listed as Physical Disk: port 0 to Physical Disk: port 3. From the
front of the appliance, Physical Disk: port 0 is the hard drive installed on the far left and Physical Disk: port 1
to Physical Disk: port 3 are installed beside each other from left to right.
If more than one drive has failed, immediately shut down your system and contact Avigilon Technical
Support for possible recovery instructions.
To replace a failed hard drive, complete the following steps.
1. Exit all running programs and shut down the Windows operating system.
2. Disconnect the appliance from power:
a. Undo the plastic clip securing the power cable to the power receptacle at the rear of the
appliance
b. Unplug the power cord.
Replacing a Hard Drive
in the web browser.
40