Motorola Avigilon 3 Series User Manual page 46

Resetting the Internal PoE Switch to Factory
Defaults
Use the reset switch on the front of the appliance to reset the internal PoE switch to its factory default
settings. Resetting the switch to factory default settings also resets the user password back to the
appliance's serial number.
Important: The reset action causes a hard reset of the device. Sometimes this results in an
improper shutdown of Windows. Any Windows warning regarding an improper shutdown upon
rebooting can be ignored after the reset switch is pressed.
The reset switch is located at the front of the appliance and is the small unlabeled hole between the
Avigilon logo and the
After you've located the reset switch on the appliance, complete the following steps:
1. Using a straightened paperclip or similar tool, gently press and hold the reset switch.
CAUTION — Do not apply excessive force. Inserting the tool too far will damage the
appliance.
2. Do not release the reset switch until you hear a confirmation beep, which takes about 12 seconds.
Resetting the Internal PoE Switch to Factory Defaults
status LED.
38