Ferris SNAPPER PRO IS500Z Operator's Manual With Setup Instructions page 25

Coflector Jflstaflatm
InstalJ ColJector Mount PJate
(S150X & S2OOX Series)
1. Remove the carb. shield plate from top of the rear
bumper.
2. Install the collector mount plate (A, Figure 40) and
mount tabs (B) on to the bumper. Install the 3/8-
16 x 1-1/4" bolts (C) and 3/8" SAE washers (F)
through the mount tabs and loosely secure with
the 3/8-16 nylock flange nuts (E).
3. Install the 3/8-16 x 1" bolts (D) and 3/8" SAE
washers (F) through the bottom mounting holes
and loosely secure with the 3/8-16 nylock flange
nuts (E).
4. Tighten the bottom mounting bolts securely.
®
Figure 40. install ColJector Mount Plate
A. Mount Plate
B. Mount Tab
C. 3/8=16 x 1-1/4" Bolt
D. 3/8=16 x 1" Bolt
E. 3/8-16 Nylock Flange Nut
E 3/8" SAE Washers
5. Temporarily install the collector mount posts (A,
Figure 41) into the collector plate and install the
hitch pins (B). This will insure that the holes are
properly aligned for easy installation and removal.
6. Tighten the top mounting bolts (C, Figure 37)
securely and remove the hitch pins and mount
posts.
Figure 41. install Mount Posts & Hitch Pins
A. Mount Post
B. Hitch Pin
23