Table of Contents
Advertisement
BlowerJflstaflatm
3. Check the belt tension by measuring the distance
from the center of the v-idler pulley (A, Figure 29)
mounting bolt and the blower housing. This
should measure between 3 - 3-3/8" (7,6 - 8,6 cm).
4. If measurement falls outside of this range, you
must move the idler pulley (B) either forward or
back to achieve the proper belt tension.
NOTE: If pulley position needs to be adjusted, make
sure that it is reinstalled in the same row of holes as
determined in the blower assembly (Step 13, page
11).
Figure 29. Check Belt Tension
A. Vqdler Pulley
B. Idler Pulley
5. install the blower belt guard (A, Figure 30) and
secure with the flange head bolts previously
removed.
6. install the deck guard top (B) and secure with the
supplied knobs (C).
Figure 30. Install Guards
A. BJower Belt Guard
B. Deck Guard Top
C. Knob
18
www.ferrisindust ries.com
Advertisement
Table of Contents
