Table of Contents
Advertisement
Set Foot Switch to trigger Part 2
Part 2 can be activated by an attached foot switch after completing the following steps.
•
Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
•
Press F#1 on the keyboard to select 'FC Trg Part 2'.
•
The [Arrow down/up] Part 2 buttons now blink. Press one of the [Arrow down/up] buttons depending on which behaviour you want
assigned to the foot switch.
•
Press [Enter] (C3) to accept the change and exit Setup. The foot switch now activates part 2.
To revert to previous foot switch settings, repeat the above steps, then press the button currently assigned in step 3, to de-assign it.
Part 2 Octave
Part 2 buttons can be assigned to shift the octave of played notes by up to 3 octaves in either direction depending on whether you press
the Part 2 [Arrow down] or [up] button. The default octave setting is set to 1, but because Layer is also on, the octave is layered with the
played note.
•
Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
•
Press G1 on the keyboard to select Part 2 'Octave'.
•
Enter an octave offset value between 0-3, using the black number keys labelled 0-9. A value of 0 sets octave to off.
•
Press [Enter] (C3) to accept the change and exit Setup.
Part 2 MIDI Channel
If you are playing an instrument which is capable of playing sounds on different MIDI channels, you'll be able to play a different sound by
changing the MIDI channel when a Part 2 button is pressed. If Layer is on, MIDI note events will be sent on both the global MIDI channel
and the Part 2 MIDI channel, playing 2 sounds at the same time.
•
Press the [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
•
Press G#1 on the keyboard to select Part 2 'MIDI Ch.'
•
Enter a MIDI channel value between 0-16, using the black number keys labelled 0-9. Select 0 if Part 2 MIDI channel should be off.
•
Press [Enter] (C3) to accept the change and exit Setup.
Part 2 Transpose
As with octave, Part 2 buttons can be assigned to transpose notes played by up to 11 notes in either direction.
•
Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
•
Press A1 on the keyboard to select Part 2 'Transpose'.
•
Enter a transpose value between 0-11, using the black number keys labelled 0-9. A value of 0 sets Transpose to off.
•
Press [Enter] (C3) to accept the change and exit Setup.
Part 2 Layer
Part 2 Octave, MIDI channel and Transpose settings can be layered with the note played when Part 2 Layer is on. When set to off, Part 2
settings replace the note played.
•
Press [Shift]+[Internal] to activate Setup mode. The [Internal] button blinks while Setup is active.
•
Press A#1 on the keyboard to select Part 2 'Layer'. The status of Part 2 Layer is immediately changed and the unit exits Setup mode.
www.nektartech.com
Part 2 - Setup mode
Nektar Impact LX Mini owner's manual 17
Advertisement
Table of Contents
