Page 2
RS232-Ethernet Interface EN-1 INTRODUCTION The OHAUS RS232-Ethernet Interface Kit is a unique solution that allows the user to connect a balance to the Ethernet. It can be used with OHAUS products that have the RS232 interface. SYSTEM REQUIREMENTS Ethernet Interface ...
3. Open the IE Browser and enter the default IP address of the Ethernet Interface Kit "169.254.1.1" ( ), the browser will show below page: User: ohaus Password: ohaus 4. Click the "Network Configuration" on the left side, and input the user name and password. Then click "OK" to proceed.
Page 4
RS232-Ethernet Interface EN-3 Note: To use DHCP, enable the DHCP: To use static IP address, disable the DHCP: and then set the Ethernet configuration parameters. Ethernet Connection The Interface has a default static IP Address, 169.254.1.1, and can be changed by following above steps.
Page 5
EN-4 RS232-Ethernet Interface COMPLIANCE Compliance to the following standards is indicated by the corresponding mark on the product. Marking Standard EN 55032 (Class B), EN 55024 EN 55032 (Class B) FCC Part 15 (Class B) FCC Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 6
RS232-Ethernet Interface EN-5 Disposal In conformance with the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies to countries outside the EU, per their specific requirements. Please dispose of this product in accordance with local regulations at the collecting point specified for electrical and electronic equipment.