Table of Contents
Advertisement
1
Partially install two of the switch housing
screws found in the
3
Align the notches in the sides of the
lower switch housing with the upper
switch housing screws. Lift the lower
switch housing. Twist the lower switch
housing clockwise to lock into place.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x2
Note:
Fan style may vary.
Ceiling Bracket
Wiring
Assembling the Light
2 of 3
Light Kit Screw
bag
bag.
Installing the Bulbs and Glass
Downrod
Hanging Fan
2
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
4
bag
Install the last light kit screw.
Tighten all three screws securely.
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Press the globe and globe
keeper flush against the metal
plate. Thread the light pull chain
through the hole in the center of
the finial cap and thread the fan
pull chain through the hole in the
side of the cap. Finally, thread
only the light pull chain through
the hole in the finial and screw
the finial onto the threaded rod.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy
Blades
1 of 3
Light Kit Screw
WARNING
ON
Light
Glass/Bulbs
1886
8
Advertisement
Table of Contents
