Hunter Pro's Best Installation Manual page 6

1886
Follow below if you are using the downrod that came pre-assembled in your box. Need to install a longer or shorter downrod? Check out the
guide at the end of this manual.
DO NOT
REMOVE
SETSCREW
COMPLETELY
Back out the pre-installed
setscrew so that the setscrew's
threads are still engaged while
the shank does not protrude
and obstruct the insertion of the
downrod.
A
Insert the downrod ball
screw (A) into the hole in
the top of the downrod ball.
5
Ceiling Bracket
Installing the Downrod
D
Guide the downrod ball (C),
sleeve (D), and downrod
(B) down the wires coming
from the fan.
NOTICE
Make sure wires are not being
tangled while twisting.
Hand tighten the downrod
(at least 4-5 full turns)
until it stops.
Wiring Downrod
C
B
Slide the downrod sleeve
(A) up the downrod. Insert
the down rod pin (B) into
the pin hole (C) on the top of
the downrod. Make sure the
down rod pin does not split
the wires. Wires will need to
be either on one side of the
down rod pin or the other to
avoid entanglement.
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
Hanging the Fan
Hanging Fan Canopy
C
B
A
A
Slide the downrod ball (A) up
the length of the downrod
pipe. Align the downrod pin
(B) with the notches in the
downrod ball (A).
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
• Pin must be reinserted to secure
downrod assembly
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Place the downrod ball into
the slot in the ceiling bracket.
Blades Light
B
Glass/Bulbs