Sylvania 6427GFG Owner's Manual page 7

ii !!!!i i i i i i i i i i i ii illi iiiii!iiii iiiiiiiiiiiiiiiiiiii
RSEPA.ATIO. FO. U SE
This section describes how to connect this TV to reception and other sources.
[ANTENNA / BASIC CABLE CONNECTION]
1/When connectinc! TV to antenna
Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack of this TV.
2/When connectincl TV to basic cable (without box'}
Connect the RF cable or incoming cable on your home outlet to the ANT. IN jack of this TV.
ignn|
RF Cable
. CABLES NOT _NCLUDED
or
Incoming Cable
Rear of this TV
Antenna Selectol
(if necessary)
• C©MMERO_ALW AVAILABLE
w
09
¢t,
O
O
t_
LLI
¢t"
O,.
0o
w
0
o
NOTES:
. For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT IN jack before moving the unit.
° If you use an antenna in order to receive analog TV, the same antenna generally will work for DTV reception.
Outdoor or attic antennas will be more effective than set-top versions.
. Some cable channels cannot be viewed when the TV is connected to an aerial antenna because DTV program does not cover all
cable channels. You can watch them by switching to the cable connected to CATV.
. To easily switch between antenna and cable wires, you can purchase '_Antenna Selector" commercially available.
*Once connections are completed, turn on the TV and begin initial setup.
Channel scanning is necessary for the TV to memorize all available channels in your area if using antenna
or basic cable. (Refer to "INITIAL SETTINGS" on page 13.)
EN