Table of Contents
Advertisement
Connecting
a computer
@
To connect a computer using VGA:
1 Plug a VGA cable (4) into the VGA port on
the computer (6) and into the RGB INPUT
port on the back of your TV.
2 Plug an audio cable (5) into the audio jack on
the computer (6) and into the AUDIO RGB
INPUT port on the back of your TV.
3 Turn on your TV.
4 Press INPUT, then press A/V
to select RGB.
To connect to a computer or other HDMI
device using the HDMI1 jack:
1 Plug an HDMI cable (2) into the HDMI port on
the HDMI device (3) and into the HDMI1
INPUT port on the back of your TV.
2 Turn on your TV.
3 Press INPUT, then press A/Y
to select
HDMI1.
To connect to a computer or other HDMI
device using the HDMI2 jack:
1 Plug an HDMI cable (8) into the HDMI port on
the HDMI device (3) and into the HDMI2
INPUT port on the side of your TV.
2 Turn on your TV.
3 Press INPUT, then press A/V
to select
HDMI2.
Note
When the computer goes into standby, TV shows
"No Sync" message and will never turn off.
Using the basic controls
Turning
To turn your TV on and off:
1 Press POWER on the side of your TV or on
the remote control. The power indicator turns
blue.
2 To turn off your TV, press POWER again. The
power indicator turns red.
Adjusting
the volume
You can adjust the volume using the controls on
your TV's side panel or the remote control.
To adjust the volume:
1 Press VOL+ or VOL- to increase or decrease
the volume.
2 Press MUTE to mute the sound, then press
this button again to restore the sound.
Changing
the video
mode
Your TV supports multiple video modes.
To select the video mode:
•
Press INPUT one or more times to select the
video mode, then press OK. You can select:
•
TV
•
HDMI1
•
HDMI2
•
AVl(Video)
•
AV2(Video)
•
AV3
•
RGB
•
AVl(S-Video)
•
AV2(S-Video)
the TV on and off
Using your TV
Selecting
the TV signal source
To select the TV signal source:
1 Press MENU, then press 4/!1_ to highlight
Channel icon. The Channel menu opens.
Channel
TV Source
Cable
Auto Scan
J_
Favorites
List
J_
Channel No.
1-2
Channel Label
Sencore
DTV Signal
Strong
2
3
Press V to enter the Channel menu.
Press A/V
to select TV Source, then press
4 / _ to select Air or Cable.
•
Air-VHF/UHF
channels.
12
Advertisement
Table of Contents
