Advertisement
4-Channel Recording
mage omecel eae
|
'The input jacks (MIC, LINE IN, or both) and REC LEVEL controls of
alt four channels are used. Parform the fundamantal steps @ to
© and continue with the following steps @ to ©.
@ Sot all four MONITOR switches to SOURCE.
© Adjust all four record lavels at thelr rospactive controls. For o
correct record level sotting refer to chapter "RECORD LEVEL
ADJUSTMENT" on page 14.
© Set all four REC MODE switches to REC. The red Jamps in the
WU-metera will light to indicate that the recorder is ready for
4-channel recording,
@ While fully deprassing the REC bution, push the Be button.
'The cecording will start. Ag the four tracks corresponding to
the four channels cover the full width of the tape, you eannot
tecord on the reverse side of the tape. So you have to rewind
the tape at the end of the recording.
2-Channel Recording
For conventional 2-channel stereo recording only the tront
inputs
'and controls are used. After baving performed the fundamental
steps @ to @, proceed with stops @ to @.
'Set the Front MONITOR switches to SOURCE.
© Adjust the FRONT REC LEVEL controls. For acorract record lovel
setting refer to paragraph "RECORD LEVEL ADJUSTMENT " on
page 14
@ Set the Front REC MODE ewitches to REC.
Tha red lamps in
the FRONT VU-meters wll Ught indicating that the recorder is
raady for 2-chennel recording.
Leave the REC MODE switches
of the back channels in PB postion.
® Whilo fully depressing the REC button (The red lamp in the
button will light), push the forward-button pm to start the 2-
channel recording. Now the recording is made en track 1 ond
track 3.
© For reéording on the remaining two tracks, depress thom button
at the end of the tape, reverte the teals and repeat stop 10.
"
Advertisement
