Connecting Another Unit To This Unit; Maintenance - Pioneer XR-P770F Operating Instructions Manual

CONNECTING ANOTHER UNIT TO THIS UNIT
MAINTENANCE
Cleaning the head section
The heads, capstan and pinch roller are parts which are liable to
get dirty quite easily. In particular, ifthe heads are dirty, the high
frequency components of the sound will not be reproduced and
the stereo balance will be impaired, resulting in a deterioration
of sound quality. It is therefore recommended that the head
section be cleaned regularly.
1. Turn the power off.
2. Press the Eject button 4 to open the cassette door.
3. Dip acleaning swab into head cleaning fluid and use it to wipe
the head, capstan, and pinch rollers. Wait 2-3 minutes until the
cleaning fluid dries.
NOTE:
This unit uses a head-slant standby system, with the result that
the heads are mounted at an angled position.
Pinch roller
e The illustration shows TAPE I.
30
<ARB7110>
e!f you connect a Pioneer CD player that has acontrol jack, youcan
use this unit's remote sensor.
1, Connect this unit to a other unit (Pioneer CD player, ete(p.5)).
2. Press the MD/CD il function button.
3. Operate the unit.
In case of a Pioneer CD player, operate with this unit's remote
control CD I! play button or with the CD player's remote
control.
Refer to the other unit's operating instructions for details
concerning operation.
NOTES:
e /f the function is not set to MD/CD Il, the connected other unit
cannot be operated.
e /f the output jack of the other unit is not connected to this unit's
IN (MD/CD II) jack, the other unit cannot be operated.
Demagnetizing the cassette deck heads
The deck heads may become magnetized after the deck has
been used for a long period of time, or if a magnet or other
magnetized object (screwdriver, etc.) is brought near the heads.
Magnetization of the heads results in increased noise and
reduced ability to reproduce high-frequency sounds.
In this case, please use a commercially available head
demagnetizer at regular intervals to eliminate the magnetic
field on the heads. When using a head demagnetizer, turn this
unit's power switch ON. In order to prevent adverse effects on
the receiver and speakers, however, be sure to turn down the
receiver's volume control to its lowest position, and disconnect
any headphones from their headphones jack. For details, consult
the instructions accompanying your head demagnetizer.
Maintenance of external surfaces
e Use a polishing cloth or dry cloth to wipe off dust and dirt.
@When the surfaces are dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
wrung out well, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners.
'@Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode the
surfaces.