Removing The Ribbon - IBM 5225 Operator's Manual

Removing the Ribbon
4-2 GA34-0054
This chapter describes how to remove and install the ribbon and the ribbon shield.
If printing is too light or incomplete, the ribbon is folded or frayed, or the ink is
exhausted. When any of these conditions exist, change the ribbon.
If printing is light but the ribbon is not folded or is not badly frayed, you may
extend the life of the ribbon by turning it over.
1. Raise the top cover.
Note: The printer cannot operate with the top cover open. This is for your
safety. If the printer has the audible alarm (optional), press the Stop Reset
key to switch off the alarm.
2. Release the forms feed by pushing down on the release latches
O·
3. Turn one of the ribbon reels
8
to relieve the ribbon tension.
4. Lift the two ribbon reels and the ribbon up and away from the four ribbon
guides
Q.