Panasonic SC-AK29 Operating Instructions Manual page 31

Problem Probable cause(s) Suggested remedy I Reference
I
page(s)
When there Is a television set nearby
The picture on the "rv The location and orientation of the antenna If you are using an indoor antenna, change
disappears or stripes appear are incorrect, to an outdoor antenna. 7
on the screen. _ wiring at the back of the system is Separate the antenna wire of the TV sot
unsuitable, from the system.
While using the cassette deck
Sound is low, intermittent, Heads are dirty. Clean the heads. See below
poor quality, noisy, scratchy,
or unsteady.
The deck does not enter the The erase-provantion tabs are removed Attach tape to cover the space left by 20
recording mode. from the cassette, removal of the eraso-prevention tabs.
While listening to compact discs
Set the disc with the label facing upward.
Wipe the disc with a soft cloth.
Replace the disc with a new one.
The display dons not show
the correct indication. Disc
play does not start when
you press the play button.
A certainmusic passage
can't be played correctly.
"TAKE OUT/DISC" appears
on the display.
The disc is upside down.
The disc is dirty.
The disc is scratched.
The disc is badly warped.
disc is a nonstandard one.
There is condensation inside the CD
changer.
The disc is dirty.
There was a power failure or the power cord
was d_soonnested from the household AC
outlet
• durincj disc changing operation or
• when the disc tray is opened.
Replace the disc with a different one.
Wait for 60 minutes before using the CD
player.
Wipe the disc with a soft cloth.
1. Press leA, POWER] to switch on the
power, The tray will open.
2. Take out CD from the tray if there is any,
then press [_1 of [CD 1] to close
the tray. The system will restore normal
operation.
While using the remote control
"Rtesystemcannot be The batteriesare instaJled in the reverso
operatedwith the remote polarity.
oontro.
The batteries are run-dow_.
15
14
14
14
Re-insort the battehes in the correct
polarity. 5
Replace the batteries with new batteries. 5
I If Ihe surfaces are dirty ]
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft c|oth dipped in a soap
and-water solution or a weak detergent solution.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructionsthat came
with the cloth carefully.
I For a cleaner crisper sound
Clean the heads regularly to assure good quality playback and
recording.
Use a cleaning tape (not included).
II
_J