Toro Power Max Heavy Duty 826 OXE Operator's Manual page 14

5. Move the choke to the C
Figure 29
6. Move the throttle to the F
Figure 30
7. Start the machine by pulling the recoil-start handle or
pressing the electric-start button
position (Figure 29).
HOKE
G016501
position (Figure 30).
AST
G016504
(Figure 31).
1. Electric-start button
2. Electric-start plug-in
To use the electric starter (electric start only), connect a
power cord to the electric-start plug-in first and then
to a ground fault circuit interrupter (GFCI) power
outlet. Use only a UL-listed, 16-gauge power cord
recommended for outdoor use that is not longer than
15 m (50 ft).
Important: Do not use a worn or damaged power
cord.
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged,
do not operate the machine. Replace or repair
the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds on,
5 seconds off), no more than 10 times. If the
engine still does not start, take the machine to an
Authorized Service Dealer for service.
8. Disconnect the power cord from the power outlet first
and then from the machine (electric start only).
9. Allow the engine to warm up; gradually move the
choke toward the R
run smoothly before each choke adjustment.
CAUTION
If you leave the machine plugged into a power
outlet, someone can inadvertently start the machine
and injure people or damage property.
Unplug the power cord whenever you are not
starting the machine.
14
g019055
Figure 31
3. Recoil-start handle
position. Wait for the engine to
UN