Recording Using The Receiver; Reverting To The Factory Default Settings - Sony PS-LX310BT Operating Instructions Manual

Recording Using the
Receiver
You can record sound from an audio device
using the receiver. Refer to the operating
instructions supplied with your recording
device.
1
Press the input button which
corresponds to the playback
device.
2
Prepare the playback device
for playing.
For example, insert the CD you want to
copy into the CD player.
3
Prepare the recording device.
Insert a blank MD or tape into the
recording device (connected to AUDIO
INPUT 4 OUT jacks).
4
Start recording on the
recording device, then start
the playback device.
Note
• The recorded music is limited to private use
only. Use of the music beyond this limit requires
permission of the copyright holders.
• Sound adjustments do not affect the signal
output from the AUDIO INPUT 4 OUT jacks.
• While the source is being recorded, the auto
standby function of the receiver may start up
and interrupt the recording. In this case, set the
"AUTO.STBY" to "STBY OFF" (page 28).
• You can record the sound from the visual device
connected to this receiver. However, you cannot
record the image via this receiver.
Reverting to the Factory
Default Settings
You can clear all memorized settings and
restore the receiver to the factory default
settings by the following procedure.
Be sure to use the buttons on the receiver
to perform this operation.
1
Press  (power) to turn off
the receiver.
 (power)
2
Press and hold  (power) for
5 seconds.
"CLEARING" appears on the display
panel during initialization. When
initialization is complete, "CLEARED "
appears on the display panel.
 (power)
Note
It takes a few seconds for the memory to be
cleared completely. Do not turn the receiver off
until "CLEARED " appears on the display panel.
31 GB