Using The Controller - D-D The Aquarium Solution Funktion Product User Manual

EN

USING THE CONTROLLER

The multifunction controller can be used to set the power output of the
pump, select the flow mode, pause the pump for feeding, or to turn the
pump on and off.
Adjusting the Mode
Mode
To change the mode of the pump press the button, with each press
of the button the controller will move through the available options.
Pump – Constant flow at a single adjustable set speed.
Pulse – The flow will alternate between low and high speed settings.
Wave – The flow will ramp up and down between low and
high speed settings.
Storm – The pump will perform a random flow pattern.
Changing the Power Output
The power of the pump can be set by pressing the button. Press once
n
and 'Maximum Power' will appear on the screen, use the buttons to
set the maximum power of the pump between 30 and 100, press the
n
again and 'Minimum Power' will be shown, use to set the minimum
power (This can only be used for the Pulse and Wave modes). The controller
will save the setting and return to the normal screen after 5 seconds of no
buttons being pressed.
Changing the Wave Frequency
In Pulse and Wave modes the frequency that the pump changes between
Mode
the low and high power setting can be changed. Press and hold the
button until 'Frequency' appears on the screen, then use the buttons
to set the frequency between 0.5 seconds and 10 seconds. The controller
will save the setting and return to the normal screen after 5 seconds of no
buttons being pressed.
Feed Mode and Turning the Pump ON/OFF
;
Press the button to put the pump into feed mode, this will pause the
pump for 10 minutes after which time the pump will return back to its last
setting. During this period a countdown timer will be displayed on the
screen, to cancel feed mode before the timer ends, press the button again.
6 Funktion controllable multi-function pumps www.theaquariumsolution.com