Table of Contents
Advertisement
2. Optional: Install the scrapers to enhance suction effect if the pool floor is full of debris or particles.
It is not recommended to install the scrapers if the pool bottom is uneven or full of pits. That avoids
the PoolBot from getting stuck by the rough floor.
3. Attach the retrieving hook to a standard 1¼ inch diameter pool pole (not included).
Using the PoolBot
1. Charge the battery
Fully charge the PoolBot before each use. Attach the charging connector to the charging socket
at the bottom of the PoolBot. Place the PoolBot in its upright position and then, plug in the charger.
The indicator lamp on the charger shall turn red when charging. It should turn green once fully
charged.
NOTE: The PoolBot must be charged indoor.
Power
Button
Charging
Socket
8
LED Indicator
Red - Charging in Progress
Green - Fully Charged
Advertisement
Table of Contents
