Table of Contents
Advertisement
Troubleshooting Guide
Issue
The PoolBot does not
change direction
(rebound) when
hitting the pool wall.
The LED indicator does
not light up when the
charger is plugged in.
The PoolBot does not
vacuum the entire
pool floor.
The buzzer does not
beep when removed
from water.
Scenario
The flipper does not flip
pward when approaching
the pool wall.
- - - -
- - - -
The PoolBot keeps bouncing at
the same direction, some
areas are always missed.
The pool's pump filter
system is on.
- - - -
Possible Cause
The flipper is stuck and does
not turn freely.
No power output from the
wall outlet
Faulty charger
Improper maneuvering
pattern setting
Irregular pool shape
Water current inside the pool
affects the maneuvering of
the PoolBot.
Battery level is low
12
Solution
Hose off the dirt around the
hinge of the flipper. Make sure
the flipper turns freely.
Check the power with a
multimeter or another
appliance. Seek help from a
licensed electrician.
Call customer service
and request for a
replacement charger.
Try different maneuvering
patterns. Refer to the
"Adjusting the Maneuvering
Pattern" section in the
user guide.
Turn off the pool's filter pump
when using this product.
Recharge the PoolBot.
Advertisement
Table of Contents
