Yaesu FT-736R Technical Supplement page 110

F. 430 MHz PLL Sub Loop (on 430 MHz ee
PLL Unit - requires DC voltmeter)
1. Connect the DC voltmeter between 3.
TP8001 and chassis ground.
2. Tune the transceiver to 4xx.01999
MHz, CW mode, and adjust L8004 4,
for 4.2V on the voltmeter.
3. Retune the transceiver to 4xx.02000
MHz and confirm at least 0.6V on
the voltmeter.
4. Disconnect the voltmeter.
wo
G. 430 MHz PLL VCXO (on 430 MHz PLL
Unit - requires RF voltmeter and DC i
voltmeter)
1. Connect the RF voltmeter to the
exposed lead of R8015, and the DC
voltmeter between the exposed lead
of R8017 and chassis ground.
RX UNIT ALIGNMENT POINTS
— 58 —
Tune the transceiver to 4xx.01999
MHz, CW mode.
Adjust T8001 for maximum RF vol-
tage, and then adjust L8016 for
6.5V on the DC voltmeter.
Retune the transceiver to 4xx.02000
MHz and confirm at least 1.0V on
the DC voltmeter.
Retune the transceiver to the
center of the band, FM mode, and
move the RF voltmeter to J8001.
. Adjust T8002 and CV8001 for maxi-
mum on the RF voltmeter.
Disconnect the voltmeters.