Table of Contents
Advertisement
To service pre-cleaner, wash in liquid detergent and
water. Squeeze dry in a clean cloth. Saturate in engine
oil. Squeeze in clean, absorbent cloth to remove ALL
EXCESS oil. If very dirty or damaged, replace it.
To service cartridge, clean by tapping gently on a flat
surface. If very dirty or damaged, replace it. Do not oil
cartridge
•
Reassemble retainer on pre-cleaner and cartridge
(screen side of pre-cleaner toward cartridge pleats.)
Install this assembly in cover.
•
Insert tabs on cover into slots in base. Tighten cover
screws securely.
Clean
Guard/Muffler
Do not clean with a forceful spray of water because water
could contaminate fuel system. With a brush or cloth
clean finger guard after every use to prevent engine
damage caused by overheating.
Before running engine, clean muffler area to remove
all combustible
debris.
_//_
CLEAN
Clean
and Replace
Spark
Plug
Change the spark plug every 100 hours of operation or
once each year, whichever comes first. This will help
your engine to start easier and run better.
.030" (0.76MM)
WIRE GAUGE
RESISTOR
Carburetor
The carburetor of your generator is pre-set at the factory.
The carburetor should not be tampered with. If your gen-
erator is used at an altitude in excess of 4000 feet, perfor-
mance may be affected.
If so consult with your nearest
Sears Service Center regarding high altitude set changes.
Governor
Your engine governor maintains the constant operating
speed of your generator. DO NOT tamper with the engine
governor which is factory set for proper engine speed.
Over-speeding your engine above factory high speed set-
ting can be dangerous and could possibly cause personal
injury or property damage. If you believe the engine is run-
ning too fast or slow, take your generator to a Authorized
Sears Service Center for repair and adjustment.
I CAUTION: Low engine speeds impose a heavy load
I
on the engine and when sufficient power is not avail-
I
able the engine life could be shortened.
14 -- ENG
Advertisement
Table of Contents
