Initial Inspection; Installation Data - HP 6177B Operating And Service Manual

SECTIOfl' If
Ir;STALLA liON
2-1 INITIAL INSPECTION
2-2 Before shipment, this instrument was in-
spectec and found to be free of mechanical and
eiectrical defects. As soon as the instrument is
unpacked, inspect for any
carnage
that may have
occurred in transit. Save all packing materials
until the inspection is completed. If damage is
found, file a claim for damage with the shipper.
Hewlett-Packard Sales and Service Office should
De notified.
2-3 MECHANICAL CHECK
2-.s. This check should confirm that there are no
broken knobs or connectors, that the cabinet and
panel surfaces are free of dents anc scratches,
and that the meter is not scratched or cracked.
2-5 ELECTRICAL CHECK
2-6 The instrument should be checked against
its electrical specifications. Section V includes
an Hin-cabinet" performance check to verify proper
instrument operation.
2-7 INSTALLATION DATA
2-8 The instrument is shipped ready for bench
operation.
It
is necessary only to connect, the in-
strument to a source of power and it is ready for
operation.
2-9 LOCATION
2-10 This instrument is air cooled. Sufficient
space should be allotted so that a free flow of
coolin~
air can reach the sides and rear of the in-
strument when
it
is in operation.
It
should be used
in an area where the ambient temperature does not
!=-xceed 50°C.
2-11 OUTLINE DIAGRAM
2-12 Figure 2-1 illustrates the outline shape and
dimensions of the 6177B and 6181B supplies.
2-13 RACK MOUNTING
2-14 This instrument may be rack mounted in a
standard 19 inch rack panel either alongside a sim-
ilar-unit or by itself. Figure 2-2 shows how both
2-1
Figure 2-1. Outline Diagram
types of installations are accomplished.
2-15 To mount one, or two units side-by-side,
proceed as follows:
a. Place adaptor frame on bench.
b. Remove feet from submodular instruments.
Place instrument(s) in frame.
c. Place divider clamps between instruments.
d. Place divider c lamps in position on each
end and push the instrument combination into frame.
e. Insert screws on either side of frame and
tighten.
Figure 2-2. Rack Mounting One and Two Units
•
•