Cabinet construction 45
4
Cabinet construction
10
Contents of this chapter
This chapter gives instructions on how to install the modules and additional equipment
into a cabinet.
For general instructions, see
Drive modules cabinet design and construction
instructions (3AUA0000107668
[English]).
Limitation of liability
The installation must always be designed and made according to applicable local laws
and regulations. ABB does not assume any liability whatsoever for any installation
which breaches the local laws and/or other regulations. Furthermore, if the
recommendations given by ABB are not followed, the drive may experience problems
that the warranty does not cover.
North America
■
1)
Installations must be compliant with NFPA 70 (NEC)
and/or Canadian Electrical Code
(CE) along with state and local codes for your location and application.
1)
National Fire Protection Association 70 (National Electric Code).
Energy storage
Obey the instructions of the energy storage manufacturer.
Liquid pipe connector installation instructions
These instructions are applicable to the liquid pipe connectors that are used in ABB
drives. There are two types of connectors: type A and type B. Refer to the illustrations