Advertisement
Available languages
Available languages
Know Your Yard Vacuum
Read this operator's manual and safety rules before operating your Yard Vacuum. Compare the illustrations
below with your equipment to familiarize yourself with the location of various controls and adjustments. Save
this manual for future reference.
The operation of any Yard Vacuum can result in foreign objects being thrown into the eyes,
which can result in severe eye damage. Always wear safety glasses, provided with the
Yard Vacuum, for operating this equipment or while performing any adjustments or repairs on
it.
Starter
Chute
/_ag Handle Blower Chute__
Throttle Control/
Choke Lever
/
/
Wire
Nozzle Height
Adjustment Lever
_lozzle
OPERATING C ONTROLS ( see
Figure6)
Chipper Chute
Allows twigs and small branches up to 1 1/2" in
diameter to be fed into the impeller for chipping.
Nozzle
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding.
Bag
Collects shredded material fed in through the chipper
chute or vacuumed in through the nozzle.
Blower Chute
When attached to unit, the blower chute is used to
blow or scatter yard waste such as leaves, pine
needle, or small twigs across yard.
Bag Handle
Used to grasp bag in order to assist in attaching,
removing, and emptying bag.
Figure 6
Nozzle Height Adjustment Lever
Used to adjust the nozzle ground clearance ranging
from 5/8" to 4 1/8".
Throttle Control / Choke Lever
This single lever controls the engine speed, stop
function, and the choke of the carburetor. Through
four separate positions on the lever from left to right,
the operation is as follows:
Engine
Slow/
Start/
Choke
Off
Idle
Run
Primer
The primer is used to assist in cold starting an engine.
Starter Handle
Used to start the engine.
Meets ANSI safety standards
Craftsman Yard Vacuums conform to the safety standard of the American National Standards Institute (ANSI).
7
Advertisement
