Dust Extraction; Dust Box; Reducer; Use - Parkside PMFS 200 C3 Translation Of The Original Instructions

Dust extraction

WARNING! RISK OF FIRE!
► When working with power tools that have a
dust collection box or can be connected to a
vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite.
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time. Therefore, do
not allow the workpiece to overheat and
always empty the dust box or the dust bag of
the vacuum cleaner before taking a break
from work.
Wear a dust mask!
NOTE
► Perforated sanding sheets are required for
dust extraction.

Dust box

Connecting
♦ Slide the dust box
sure that the symbol on the dust box
aligned with the ▸ symbol on the appliance.
Turn the dust box
(see detailed illustration fig. D on the fold-out
page).
Removal
♦ Turn the symbol on the dust box
▸ symbol on the appliance (see detailed illustra-
tion fig. D on the fold-out page). Pull the dust
box off the appliance.
NOTE
► To achieve optimum dust extraction, the dust
box should be emptied regularly.
PMFS 200 C3
onto the appliance. Make
to the symbol to lock it
to the
♦ To do this, remove the dust box
appliance as described above. To do this,
open the dust box
button
remove the dust bag
thoroughly by tapping it out.

Reducer

Connecting
♦ Push the reducer
♦ Push the hose of a suitable of vacuum cleaning
appliance (e.g. a workshop vacuum cleaner)
onto the reducer
Removal
♦ Pull the hose of the vacuum cleaner off the
reducer
♦ Remove the reducer

Use

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains.
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
is
the workpiece.
Switching on and off
Switching the appliance on
♦ Move the ON/OFF switch
tion.
Switching the appliance off
♦ Move the ON/OFF switch

Setting the oscillating speed

You can set the desired oscillating speed using the
speed selector
depends on the material being processed and can
be determined through practical tests.
by pressing on the release
and pulling off the rear part. Now
. Clean the dust bag
into the adapter fitting
.
.
.
in the "I" posi-
in the "0" position.
as required. The required speed
GB │ IE
off the
.
│
7 ■