Pentair PCD-1000 Installation And User Manual

Pentair PCD-1000 Installation And User Manual

Stainless steel utility pump

Advertisement

Quick Links

PCD-1000 SUBMERSIBLE PUMP
STAINLESS STEEL UTILITY PUMP
INSTALLATION AND
USER'S GUIDE
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS

Advertisement

Table of Contents
loading

Summary of Contents for Pentair PCD-1000

  • Page 1 PCD-1000 SUBMERSIBLE PUMP STAINLESS STEEL UTILITY PUMP INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
  • Page 2: Table Of Contents

    CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 4:30 P.M. — Eastern Technical Support and Pacific Times) Sanford, North Carolina (8 A.M. to 4:30 P.M. ET)
  • Page 3: Pump Warning And Safety Instructions

    Pump should always be electrically grounded to a suitable electrical ground such as a grounded water SAVE THESE INSTRUCTIONS pipe or a properly grounded metallic raceway or ground wire system. Do not cut off round ground pin. PCD-1000 SUBMERSIBLE PUMP Installation and User’s Guide...
  • Page 4: Pump Overview

    Note: No repair parts are available for Interruption of power to the pump • this pump. • Dirt/debris in the sump • Flooding that exceeds the pump’s capacity Electrical or mechanical failure in the pump. • PCD-1000 SUBMERSIBLE PUMP Installation and User’s Guide...
  • Page 5: Installation And Operation

    8. The unit is ready for operation after the piping and check valve are installed. 9. Check operation by filling sump with water and PCD-1000 Submersible Pump observing pump operation for one complete cycle. PCD-1000 SUBMERSIBLE PUMP Installation and User’s Guide...
  • Page 6: Automatic Reset Thermal Protector

    Water level is probably very low and unit has lost prime. 45° Water Level Water Level Float switch turns the pump on as it reaches Float switch rises as water level in- approx. a 45° angle. creases. Float Switch Positions PCD-1000 SUBMERSIBLE PUMP Installation and User’s Guide...
  • Page 7: Troubleshooting

    Something caught in impeller. pump. Worn or defective parts or plugged impeller. Drill a 1/16” - 1/8” diameter hole between pump and discharge and check valve. Airlock (check valve installed without vent hole). PCD-1000 SUBMERSIBLE PUMP Installation and User’s Guide...
  • Page 8 1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000 10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000 All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.

Table of Contents