Table of Contents
Advertisement
6
WARNING: THIS APPLIANCE MUST BE EARTHED!
This oven should be installed by a competent electrician
in accordance with the current edition of IEE
Regulations.
This appliance must be earthed and connected to a 230
Volt, 50 Hz, single phase supply through a suitable oven
control unit with a fuse rating of 20 amps. The control
unit should incorporate a double pole switch having a
contact separation of at least 3 mm in all poles and
should be located adjacent to the oven to allow easy
access in case of an emergency. If the oven is to be
wired into a connector unit this maybe positioned behind
the oven providing:
i.
The top of the connector unit is not more than 30cm
above the base of the oven recess.
ii. The depth of the connector unit does not reduce
the depth of the recess to less than 55cm.
We recommend that you use a rubber cable (type H0 5RR-F)
to connect the oven to the control unit or other protective
cables with similar type characteristics. The minimum
cable size is 3 x 1.5 mm2. The oven mains terminal
block is located on the rear of the oven and should be
connected as shown in the diagram. Access to the
terminals is made possible by removing the screw
Live Terminal
Neutral Terminal
Earth Terminal
Mains Cable
Cable Clamp
ELECTRICAL INSTALLATION
immediately above the black plastic terminal cover, and
hinging the cover downwards.
The power cable must be laid so that no parts of it ever
reach an over temperature of 75K.
Alternatively the mains supply can be taken from a
household 13amp switched fused spur. Having a
minimum contact clearance of 3mm, which must be
fitted adjacent to the oven housing cabinetry and
accessible after installation. The oven must be fitted
with 3 core cable having a minimum cross section area
of 1.5mm and must conform to BS6500.
The oven must not be connected using a 3-pin 13amp
plug.
Terminal
Cover
Access Screw
G107
Advertisement
Table of Contents
