Before Operation - Kenwood DP-M5560 Instruction Manual

Before operation
Disc handling precautions
Handling Cleaning
Hold compact dises so that you do not lf fingerprints or foreign matter become
touch the playing surface. | 7 attached to the disc, lightly wipe the disc
Se with a soft cotton cloth for similar} from
the center of the disc outwards in a radial
manner.
| Label side
Playing side
Do not attach paper or tape to either the
playing side or the labei side of compact Pe Storage
discs. When a dise is not to be played for a long
period of time, remove it from the CD
player and store it in its case.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player.
Therefore, to avoid danger, never use a cracked or deformed disc or
a disc repaired with tape or adhesive agent.
Note related to transportation and movement
Before transporting or moving this unit, carry out the following operations.
1. Turn the power ON but co not load a disc or magazine.
2. Wait a few seconds and verify that the display shown appears.
3. Tum the power OFF.
TAO AA
Beware of condensation
When water vapor comes into contact with the surface of cold material, Be especially careful in the following conditions:
water crops are produced. ® When the unitis brought from a cold place to a warm place, and there
lf condensation occurs, correct operation may not be possible, or the . is a large temperature difference.
unit may net function correctly. @ When a heater starts operating.
This is not a malfunction, however, and the unit should be dried. (To e@ When the unit is brought from an air-conditioned placa to a place of
do this, turn the POWER switch ON and leave the unit as itis for several high temperature with high humidity.
hours.) @ Vhen there is a large difference between the internal temperature
of the unit and the ambient temperature, or in conditions where
condensation occurs easily.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications. "
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modivications are expressly approved in the instruction manual. The user could lose the authority te operate this equipment if an unauthorized
change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
Measures.
~-— Reorient or relocate the receiving antenna.
— — Increase the separation between the equipment and receiver.
— — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— —- Consult the dealer or an experienced radio/TV technician for help.
B pp.mss60 / DP-M3360 (En)
'