Table of Contents
Advertisement
— Drill four holes in the base of the wall unit using the template
supplied.
— Mount the hood unit on the base of the wall unit using four
4,2 x 35 mm screws. — Fig.4
I I
wmmmrn
O f
'
-0-
XX
>
X
14_1
1 mu
If using an interchangeable model, fit the plastic caps supplied in
any unused mounting holes. — Fig. 5
— Position the template on the wall.
— Drill four 8 mm 0 holes in the wall, 2 in points H and 2 in points I.
— Fit the four 8 mm screw anchor plugs in the wall.
— Screw two 5 x 45 mm screws in points H but do not tighten
them fully home.
— Adjust the unit so that it is positioned at a right angle to the wall
by turning the two support screws G.
— Now hang the hood on the wall (holes H). Tighten the first two
screws and, for safety's sake, screw the other two 5 x 45 mm
screws (holes I) into the holes in the hood. — Fig. 6
Wall unit
mounting
Wall
mounting
29
Advertisement
Table of Contents
