Table of Contents
Advertisement
5. Release the key on the card to terminate the data transfer
Recording Messages through the Card Microphone (Listening on Headphones)
CAUTION: when a new recording is started, ALL previous messages are cancelled.
1. Connect the headphones directly to the AUDIO OUT jack placed on one side of the card.
2. Make sure that the microphone is enabled (jumper MIC ENABLE on the board is closed).
3. Press and hold the RECORD key located in the middle of the card until the yellow LED
switches on. After release the key.
4. As indicated by the vocal instructions, after the beep record the messages (starting from the
common message).
5. During recording, the YELLOW LED continues to flash.
6. PRESS the RECORD key to interrupt the ongoing recording.
7. Upon message recording completion, the message will be automatically reproduced.
8. Upon message reproduction completion, the vocal instructions will advise which new message
can be recorded. If you do NOT wish to record the next message, briefly press the key before
the beep to proceed to the next one.
9. Upon recording completion of the last message
automatically exit the recording phase.
Storage of SMS Messages
Each SMS message must be entered through a GSM mobile phone and stored in the SIM card,
together with the telephone number to which it has to be sent. Subsequently, each message must be
associated to a single event among the fourteen available events as the cause for its transmission.
Procedure to create and store the SMS messages :
! Insert the SIM card in any mobile phone.
! Enter the MESSAGE item in the menu
! First ENSURE that the item MESSAGES SENT is EMPTY. Should there be any messages,
delete them.
! Select from the MESSAGES menu the item SEND NEW.
! Enter the complete text of the SMS according to the routine procedure (refer to GSM mobile
phone manual)
! Confirm the text and enter the number to which the SMS should be sent.
! Save the sent message.
EXAMPLE (ERICSSON mobile )
From a GSM mobile phone press in sequence ↓
-
-
Enter the SMS message
Enter the number to which you want this SMS to be sent
-
Wait for transmission
-
Press 6 to select SENT MESSAGES
-
Select the message to be saved (the only one not displaying the SIM symbol)
-
Press YES to confirm the message and YES again to proceed
-
Select SAVE
-
The message "1 of 25 saved" means that the message saved is in the first position
-
Remember to associate the message with the transmission event
-
(total 15),
the automatic dialler will
2
3
18
Advertisement
Table of Contents
