Husqvarna 525HE3 Operator's Manual page 10

20
US gallon
1
2 1/2
5
CAUTION:
the ratio of the mixture drastically when you
mix small quantities of fuel. Measure the
quantity of oil carefully and make sure that
you get the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
WARNING:
follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
10
0.40
US fl. oz.
2 ½
6 ½
12 ⅞
Small errors can influence
Do not mix fuel for more
Obey the procedure that
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
refer to Product overview on page 2 .
To start the engine
WARNING:
of 15 m/50 ft from persons or animals when
you start the product. There is a risk that the
cutting attachment starts to move.
1. Set the choke control in the choke position.
2. Push the air purge bulb until the bulb starts to fill with
fuel.
Note:
It is not necessary to fill the air purge bulb
fully.
Make sure that there is
Keep a minimum distance
1173 - 005 - 30.08.2023