Backrest Assembly - Weider FLEX XT2 Owner's Manual

WEIDER HEALTH & FITNESS pace
STEP 5 BACKREST MOUNTING PLATE & BRACE ASSEMBLIES
PARTNAME — | am
22 5/16" NYLON LOCK NUT 2
24 5/16" X3 1/4" HEX HEAD BOLT 1
26 1/4" NYLON LOCK NUT 2
28 1/4" X 2" CARRIAGE BOLT 2
29 1/4" FLAT WASHER 1
66 5/16" X 2" HEX HEAD BOLT | c
C] Attach the front BACKREST MOUNTING PLATE (9) to the front
hole in the BACKBONE (3) by bolting with a 1/4" X 2"
CARRIAGE BOLT (28) down through the Mounting Plate and
then through the BACKBONE (3). Assemble a 1/4" FLAT
WASHER (29) onto the bolt and secure with a 1/4" NYLON
LOCK NUT (26).
L] Assemble the rear BACKREST MOUNTING PLATE (9) to the
rear hole in the BACKBONE (3) by bolting with a 1/4" X 2"
CARRIAGE BOLT (28) down through the Mounting Plate, the
Backbone, and then through one end of the BACKBONE
BRACE (10). Secure with a 1/4" NYLON LOCK NUT (26).
O To attach the STEPPER BRACE (11), place a
5/16" X 3 1/4" HEX HEAD BOLT (24) through
the slotted curled end of the STEPPER BRACE
(11), then through the MAIN FRAME (1), and
then the BACKBONE BRACE (10). Secure with
a 5/16" NYLON LOCK NUT (22).
C] Fasten the lower end of the STEPPER BRACE
(11) to the REAR BASE (2) by bolting with a
5/16" X 2" HEX HEAD BOLT (66) up through
the Rear Base and then through the Stepper
Brace Secure with a 5/16" NYLON LOCK NUT
(22).
STEP 6 BACKREST ASSEMBLY
| 44 RUBBER LEG CURL BUMPER
[64 1/4" X 1/2" ROUND HEAD SCREW
C] Position BACKREST (12) onto the BACKBONE (3) so that
the mounting holes in the brackets align with the holes in the
underside of the Backrest. Bolt in place using four 1/4" X 1/2"
ROUND HEAD SCREWS (64).
L] Fasten the RUBBER LEG CURL BUMPER (44) to the front of
the BACKBONE LEG (3) with a 5/32" X 1/2" MACHINE
SCREW (65).