Extension Telephone; Fax Activation Code - Panasonic KX-FP250 Operating Instructions Manual

Extension telephone
When you connect an extension telephone to your unit or on the same line, you can receive fax documents
using the extension telephone.
You do not have to go to the unit and press ISTART/COPY/SET].
Important:
• Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1
2
When the extension telephone rings, lift the
handset of the extension telephone.
When:
--document reception is required,
--a fax calling tone (slow beep) is heard, or
--no sound is heard,
press [] [] (pre-selected fax activation code)
firmly.
Hang up the handset.
• The unit will start reception.
To the EXT jack or
the same line
Extension telephone
Note:
• You can change the fax activation code (see
below).
Fax activation code
The fax activation code is used in the following cases;
-- when receiving faxes using an extension telephone (see above).
-- when receiving a voice message and fax document in the same call (see page 63).
Important:
• This code should be different from the remote activation ID (see page 63).
Press (_).
Display:
1 .SYSTEM SET UP
2
Press [_], then [_] [!].
{F x A CTiVATiON
Press (START/COPY/SETI.
I MODE=ON
"A I
Press _ or (_ to select the desired setting.
• If this feature is not required, select "OFF".
Press ISTART/COPY/SET).
I CODE= _ 9
• The dispi_rwill show the pre-selected code.
Enter the new code number.
• This code can be from 2 to 4 digits in length
using 0 - 9 and -x-.
Dial keypad
I
I
Press (START/COPY/SETI.
I SETUP ITEM
8 =Press _.
70
Note:
• If you subscribe to some special telephone
company services, all or part of the fax
activation code must be different from the
service access code.
• The fax activation code should not be set to
"0000".