Hitachi PSC-A32MN Installation And Operation Manual page 43

Operation
5.2.3.2 Fan Speed
1 Select the target group for the change of fan speed setting at the "Monitor (All Groups)" or "Monitor (Block)" screens. The screen
with the settings for the selected group is displayed on the touchscreen.
Monitor (All Groups)
(1)
2 By tapping " " or " " buttons under "Fan Speed", the fan speed setting changes alternatively as shown below.
* "HIGH2" or "AUTO" may not be indicated depending on the type of air conditioner.
3 Tap "Monitor screen" to return to the "Monitor" screen.
?
N O T E
• By tapping "<" or ">" at the detailed setting screen, the Fan Speed is switched to another group in the same block.
• Control Restricted (Run/Stop Only) : In case of "Enable", each Setting Change is for all Groups or Blocks.
• Setting Change is not possible for each Group.
• Actual fan speed during the dry operation is "LOW" regardless of the fan speed setting.
• The figure above shows an example of a connected Air Conditioner Unit. The Fan Speed may not be indicated in certain case.
• If the settings are mixed when multiple groups are selected, the display remains blank.
35 PMML0332A rev.0 - 05/2015
(3)
LOW
MEDIUM
HIGH
HIGH2
AUTO
(2)
Monitor (Block)
(1)