Commissioning
4
Commissioning
In order to use the transmitter box, you must first commission it. The first step is to transport the device to is
operating location and unpack it. This is followed by mounting the device on the DIN rail and connecting the
data lines and the power supply.
4.1
Transport and unpacking
Note the specified transport and storage conditions (see Chapter 8 Technical data [} 21]).
Hardware damage due to condensation
Unfavorable weather conditions during transport can cause damage to the device.
• Protect the device against moisture (condensation) during transport in cold weather or in case of
extreme temperature fluctuations.
• Do not put the device into operation until it has slowly adjusted to the room temperature.
• Should condensation occur, wait for about 12 hours before switching the device on.
Unpacking
Proceed as follows to unpack the unit:
1. Check the packaging for transport damage.
2. Remove packaging.
3. Keep the packaging for possible future transport.
4. Check your delivery for completeness by comparing it with your order.
5. Check the contents for visible shipping damage.
In case of discrepancies between the package contents and the order, or in case of transport damage,
please inform Beckhoff Service (see Chapter 9.1 Service and Support [} 22]).
14
NOTICE
Version: 2.0
CU8803-000x