Advertisement
Features
●
Power conversion efficiency > 92%.
●
6 selective charging profiles suitable for charging for the most lead acid & Lithium (LiFePO4) batteries.
●
Supplied with a remote Battery temperature sensor to ensure precise and safe charging in large
temperature variation.
●
3 types of operation control to choose for specific situation.
●
Alarm signal (fault or not charging) available to integrate with your system.
●
Thermostatically speed control Fan.
Protections
●
Self Recoverable Input Under Voltage Protection.
●
Self Recoverable Input Over Voltage Protection.
●
Self Recoverable Output Over Voltage Protection.
●
Self Recoverable Over Current protection.
●
Self Recoverable Charger Over Temperature Protection.
●
WARNING:
No input and output battery reverse polarity protection. Reverse polarity will damage the charger.
Supplied Accessories
●
Remote battery temperature sensor.
Installation Procedure
Do NOT install this unit in the vehicle engine bay.
This is a fan cooled electronic device not for use in high temperature, corrosive and dusty environment which
will drastically shortens the life and performance of the charger.
This charger is designed only for internal mounting and away from direct sunlight, heat and rain. Allow at
least 80mm of space at both ends for ventilation.
We recommend wiring by a qualified automobile electrician to ensure local safety and on-board standard are
followed
1.
To provide the best cooling effect, mount the unit in vertical position with the terminal end facing
downwards due to the top front exhaust design.
2.
First install the charger as close to the house battery as possible via a fuse.
3.
Check the LED indicators by a few presses on the Select Button.
4.
Before connect input to DC Alternator, check on type of alternator of car, for new car with smart
alternator select ether Vibration Sensor Mode or Ignition Feed Mode.
5.
Do not charge Lithium (LiFePO4) battery without built in Battery Management System.
6.
Do not charge Lithium (LiFePO4) battery below 0°C.& discharge below minus 5°C. Check with battery
maker.
Advertisement
