Table of Contents
Advertisement
Specifications
a
er
EN
OT
SR
Track System ..............
4-track, 2-channel stereo,
Harmonic Distortion......
Less than 0.6%
(at 1 kHz,
0 dB
recording/playback
with normal tape)
Recording System........
AC bias system
Wow and Flutter..........
0.08%
(W.R.M.S),
(Bias frequency:
105 kHz)
+0.22%
(DIN)
Heads...
33 n.ccees
ccaca ce Playback/record head x 1
Input sensitivity/
Playback head x 1
Impedance:
Erasing head x 1
LINE IN 200...
77.5 mV/50 kQ
Motors seciceeeenlenoen
DC motor x 2
Output Level/
Fast Winding Time .......
Approx. 90 seconds with C-60
Impedance:
tape
LINE OUT.........0.0......
270 mV/3.9 kQ
Frequency Response (+6 dB) — 20 dB recording:
Normal Tape..............
20 Hz to 15,000 Hz
' CrO Tape .................
20 Hz to 16,000 Hz
[GENERAL]
Metal Tape................
20 Hz to 16,000 Hz
Power
Consumption.....
15 W
Signal-to Noise Ratio:
Dimensions..................
W:
440 mm
(17-5/16")
Dolby C Type NR ON..
72 dB (Normal tape)
H:
119mm
(4-11/16")
Dolby B Type NR ON..
65 dB (Normal tape)
D:
268 mm
(10-9/16"}
Dolby NR OFF............
57 dB (Normal tape)
Weight (Net)................
4.6 kg (10.1 Ib)
Note:
KENWOOD
follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unautho-
rized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a CLASS B digita! device, pursuant to Part 15 of the FCG Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications,
if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—-— Reorient or relocate the receiving antenna.
—-
Increase the separation between the equipment and receiver.
-—~— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
——
Consult the dealer or an experienced radio/TV technician for help.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian department of communications."'
Note:
The unit's power supply is secondarily connected. Note following .
The unit is not completely disconnected from the mains as long
as the power cord is connected to a wall outlet.
Observera:
Bemeerk:
Apparatens strémfdrsdérjning kopplas fran sekundart. V.g. ge akt
Strammen til apparatet afbrydes pA den sekundezere side. Vear op-
pa fdljande.
mezerksom pa falgende.
Apparaten frankopplas inte helt och hallet fran stromnatet medan
Denne enhed er ikke fullstendig koblet fra lysnettet s4 lenge stik-
apparatens natsladd ar ansluten till vaxelstromsuttaget.
ket er tilsluttet stikkontakten.
Huom:
Anmerkning:
Virta yksikk66n
on
kytketty
pois sekundaaripuolelta.
Huomioi
Strammen til apparatet er slatt av pa sekundzersiden. Vaer oppmerk-
seuraava.
som pa det falgende.
Tama yksikk6 ei ole kokonaan kypketty pois paa virranjakajasta kun
Dette apparatet koples ikke fullstendig fra nettet s8 lenge stopse-
paa katkaisin on liitettyna virtatiiriin.
let stér i en stikkontakt, selv om strembryteren settes i av-stilling.
Advertisement
Table of Contents
