Table of Contents
Advertisement
DPSS
OUBBINC
i NORM
@ Rewind & auto play
This function is used to automatically play the tape from
the first tune after rewinding.
To play the forward side of the tape, press the play key >
and rewind key | << | simultaneously.
To play the reverse side of the tape, press the reverse play
key [<) and fast forward key | »» | simultaneously.
@ Dash & play
This function allows you to play a tape repeatedly by fast-
forwarding through any non-recorded blank of more than
10 seconds on the tape.
1. Set the DIRECTION switch according to the desired play-
back direction.
''== "' One side will be repeated 8 times.
''C)"' Both sides will be repeated 8 times.
2. Press the fast forward | »>
|and rewind | << | keys simul-
taneously.
® To cancel dash & play, press the stop key [im .
Notes: —--—-
1. If anon-recorded section is less than 10 seconds, this function
may not work correctly.
2. If cassette tapes are loaded in both the A and B decks with the
DIRECTION switch set to ''—>"' (reverse), when the dash & play
operation finishes on one deck, it is then carried out on the other
deck.
@ Re-Rec standby (B deck only)
This function allows you to interrupt recording, return the
tape to the position where recording started, and put the
deck in the stop mode. This is useful when you have start-
ed a recording by mistake.
(In this case, a four second blank section is required before
the position at which the recording is to start).
During forward recording, press the rewind key | <<
| .
During reverse recording, press the fast forward key | >> |.
@ Recording is interrupted, the tape is rewound to the cor-
rect starting point, a non-recorded blank of 2 seconds
is made after the end of the previous program, and the
deck enters the stop mode.
When starting to re-record
1. Press the REC/ARM key twice in succession to make a
new non-recorded blank.
2. Press the REC/ARM key again
@ This starts a new recording.
12. kx-79cw (En)
@ How to provide non-recorded blanks between
programs
To make a non-recorded blank of about 4 seconds:
Press the REC/ARM
key twice in succession.
@ After leaving a non-recorded blank of about 4 seconds,
the deck enters the record-pause mode.
To make a non-recorded blank during recording:
Press the REC/ARM
key once during recording.
® After running to make a non-recorded blank of about 4
seconds from the point where the key is pressed, the
deck enters the record-pause mode.
Note:
4
For normal recording operations, see the ''How to record' section
which starts on page 13.
Advertisement
Table of Contents
