Table of Contents
Advertisement
CLD ~ 2850
1. SAFETY INFORMATION
- VARO!
AVATTAESSA
JA — SUOJALUKITUS
OHITETTAESSA
= OLET
—ALTTIINA
NAKYMATTOMALLE
LASERSATEILYLLE.
ALA KATSO SATEESEEN.
r-~ (FOR EUROPEAN MODEL ONLY)
LASER
Kuve 1
Lasersateilyn
ADVERSEL:
USYNLIG LASERSTRALING VED ABNING
NAR SIKKERHEDSAFBRYDERE ER UDE AF
FUNKTION UNDGA UDSAETTELSE FOR
varoitusmerkki
WARNINGI
DEVICE INCLUDES LASER DIODE WHICH
EMITS INVISIBLE INFRARED RADIATION
WHICH IS DANGEROUS TO EYES. THERE IS
A WARNING SIGN ACCORDING TO PICTURE
7 INSIDE THE DEVICE CLOSE TO THE LASER
DIODE.
IMPORTANT.
THIS PIONEER APPARATUS
CONTAINS
LASER
Picture 1
Warning sign for
laser radiation
STRALING.
LASER OF CLASS
1.
'SERVICING OPERATION OF THE APPARATUS,
SHOULD 8E DONE BY A SPECIALLY
SS ANING!
INSTRUCTED PERSON.
OSYNLIG LASERSTRALNING NAR DENNA
DEL
AR
GPPNAD
OCH
SPARREN
AR URKOPPLAD. BETRAKTA EJ STRALEN
LASER DIODE CHARACTERISTICS —]
MAXIMUM OUTPUT POWER: 5 mw
WAVELENGTH: 780-785 am
LABEL CHECK
WEZ model
WB model
CAUTION
INVISIBLE LASER
RADIATION WHEN OPEN,
AVOID EXPOSURE
TO BEAM
ADVARSEL
LUSYHRIG LASenSTRALING VED ABKING AAR SiKERIED SAF.
DIVDRE ODE AF FLNRTION.
'UNOGA UOGATTELSE FOR STRAUMG.
Avattaeasa Je suosaluxitus ohitert
ease olet
alttiine nakyaattondl)
Aaversdtellylie. Ald hatao sAt
'VAROING!
Osynlig laseratrdining mdr denna del
'Ar Oppnad och sparren ar urkopplad.
Detrakta ej atrdlen.
'VORSICHT?
LUWSICHTARE LASER STRAIRUNG THITT AUS, WENN DECHEL
{BOER ELF GEPIET
aT HT DO STN. ler
oT
wens
PRW1018
\
WEZ and WS models
Additional Laser Caution
1. The ON/OFF statuses of the side~A/B detection switch
(TURN switch on the MECHANISM assembly), slider-position
detection switches (PARK 1, 2 and 3 on the MECHANISM
assembly) and loading-status detection switches (SW 1, 2
and 3 on SW board assembly} are detected by the micro-
processor (IC 101 in the MAIN board assembly).
'To permit the laser diode to oscillate, it is required to set the
side-A/B detection switch for side A (IC101 In the MAIN
board assembly, pin 60 XTURN A=L and pin 61 XTURN B=H)
'or the slider-position detection switch for the LD ACTIVE
status (PARK 1: OFF, PARK 2: OFF, PARK 3: OFF), and to
'set the foading-status detection switch for clamped state (SW
4:OFF, SW 2:0N, SW 3:0N). (These requirements assume
that the shipping screws have been removed.) As long as
these requirements are not satisfied, the laser diode will not
oscillate, When the requirements are met in any way, the laser
lode can oscillate. The laser diode oscillation will continue if
the collector and the base of Q822 in the MAIN board
assembly are shorted to each other {fault condition),
In test mode * ; the taser diode oscillates when the
microprocessor detects a PLAY signal, or when the PLAY key
is pressed ($116 : ON in the FLKY assembly), with the above
WEZ and WB model
CLASS 1
LASER PRODUCT
. When the cover is open, close viewing through the objective
lens with the naked eye will cause exposure to a Class 1 laser
beam.
+ : Referto page 64,
Advertisement
Table of Contents
