Komatsu GALEO PC40MR-2 Operation & Maintenance Manual page 204

MAINTENANCE
Increasing Track Tension
NOTICE
The standard value is low, so be careful not to tighten the rubber shoe too much.
Prepare a grease gun.
1. Pump in grease through grease fitting (2) with a grease pump.
2. To check if the tension is correct, run the engine at low idling,
move the machine slowly forward (by an amount equal to the
length of track on ground), then stop the machine.
3. Check the rubber shoe tension again, and if the tension is not
correct, adjust it again.
4. If the tension is still low after supplied grease, the rubber shoe
needs to be replaced or the seal in the cylinder needs to be
replaced. Ask your Komatsu distributor for replacement.
Loosening Track Tension
It is extremely dangerous to release the grease by any method except the procedure given below. If the track tension is not
relieved by this procedure, please contact your Komatsu distributor.
1. Loosen plug (1) gradually to release the grease.
2. When loosening plug (1), turn it a maximum of one turn.
3. If the grease does not come out smoothly, move the machine
forwards and backwards a short distance.
4. Tighten plug (1).
5. To check if the tension is correct, run the engine at low idling,
move the machine slowly forward (by an amount equal to the
length of track on ground), then stop the machine.
6. Check the rubber shoe tension again, and if the tension is not
correct, adjust it again.
7. Check the track tension again, and if the tension is not correct,
adjust it again.
WARNING
MAINTENANCE PROCEDURE
4 - 35