Hisense HV6135C Operating Instructions Manual page 16

2. Lift the filter straight up using the
handle. Free the coarse filter to clean
the fine filter.
3. Refit in reverse order. Check that the
edges seal properly when refitting the
fine filter.
4. Lock the filter in place by turning the
handle clockwise to the stop position.
The handle should point straight out
from the dishwasher.
NOTE!
NOTE!
Spray arms
Holes and bearings can sometimes
become blocked. Remove any debris
using a pin or the like. The spray arms
also have holes underneath.
To facilitate cleaning you can remove the
spray arms. Remember to fit them firmly
back into place afterwards.
16
Dishwashing results may be
affected if the filters are incorrectly
fitted. Note that the dishwasher
must not be used without the filters
in place!
Check that the coloured stop on
the right in the bottom drain is in
place.
Lower spray arm
• Pull the lower spray arm straight up to
release it.
Upper spray arm
1. Pull out the upper basket.
2. Unscrew the spray arm bearings
counterclockwise to remove the spray
arm from the upper basket.
The door and the door seal
Regularly clean the sides of the door and
the door seal. Use a slightly damp cloth
(with a little cleaner if necessary).
Front panel
Keep the buttons clean and free from
grease. Wipe them clean with a dry or
slightly damp cloth. Never use cleaners –
they can scratch the surface. Use the
main power switch to turn off the
dishwasher before cleaning the buttons
to avoid activating any buttons
unintentionally.