Advertisement
In case of difficulty
lf your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking
help from your dealer or service representative.
No power when POWER
is switched ON.
Power cord is disconnected.
Plug the AC cord into the AC outlet cor-
—
Time indication stops and blinks.
. Power line was interrupted.
. Set the current time correctly.
2. Power cord was unplugged and plugged | 2 . Set the current time correctly.
in again.
. Current time is not set. Power line was | 1 . Set the current time correctly.
interrupted.
2. The
ON
time
and
OFF
time
for the
program are not set.
. Timer program is not set for execution.
Timer operation does not function.
2. Set both
ON
time
and
OFF
time
as
required.
3. Press the [EXECUTE 1 .~ 2|key accord-
ing to the required program.
Beat noise occurs.
. Television set is used at the same time.
. Turn the television's power OFF or keep
a reasonable distance between the tele-
vision and this unit.
2. Install the AM loop antenna at the opti-
mum position.
2. The provided AM loop antenna is set too
close to the unit.
.
Buzz noise occurs.
Other electrical equipment (such as fluores-
cent lights or a hair dryer) is used at the
same time.
Stop using the equipment generating noise.
. Set the antenna as far from the tuner as
possible while changing the direction to
an optimum position.
2. Stop using the equipment
generating
noise, or keep it away from the tuner.
Distorted sound.
. The
provided
AM
loop antenna
is in-
stalled in an incorrect direction or in the
wrong place.
2. Noise is introduced from other electrical
equipment. (such as fluorescent lights or
an appliance using a motor).
3. Signal strength from the broadcasting
station is too weak.
3. Install the AM outdoor antenna and con-
nect it to the tuner.
. Connect the antenna
to the tuner cor-
antl
rectly.
oo
2. Set the tuning band correctly.
3. Tune to the required station using the
TUNING/CHARACTER key.
. Tune to the frequency of a station which
can be received, and preset into any of
the numeric keys (1~0).
2. Perform presetting operation again.
. Antenna is not connected.
FM/AM
(FM/MW/LW) reception is impos-
sible.
2. Tuning band is not set correctly.
. The required station is not tuned in.
Reception
is impossible
when
a numeric
key (1~0O) is pressed after presetting.
. Frequency
of the receivable
station
is
not preset into the numeric key (1~0).
2. The stored contents have been canceled
due to longterm interruption.
The STATION NAME AND PRESET switch
on the rear panel is set to the 12" position.
Tuned station cannot be preset into one of
the numeric keys (7 ~0)
Disconnect the power cord, then set the
STATION
NAME
AND
PRESET
switch to
the "20 " position.
18 — kt-2010/KT-20104 (En)
Advertisement
