Control System - Fostex DMT-8VL Owner's Manual

DMT-8v1 Owner's Manual (Recording/ Playback)
3. MTC Synchronization/Machine Control system
Tuis paragraph explains the control system via computer using MMC (MIDI Machine
Control) and the synchronization system using MTC (MIDI Time Code) output
from the DM
The DMT-8v.can output MIC at any frame rate by adding a time offset (with a
me difference of less than six hours) to the ARS (absolute) time of the hard disk.
You can also control the DMT-B from an external device by sending MMC (MIDI
Machine Control) or Fostex System Exclusive Messages. n this case, you wil eta
DEVICE ID number in the "DEVICE" parameter of Setup mode on the DMT-8VL.
'Therefore, multiple РМ: can be controlled individually by changing the DEVICE
ID number within the messages sent from the computer.
Refer to "ММС Lir" on page "137" for more information on MMC, and to "Fostex System
кине Ши" on page 135 for more information on оше System Exclusive Messages
When the DMT-Sve receives the MMC Rehearsal messages (WRITE: 40h, RECORD
MODE: ch), the REHEARSAL LED wil lin, indicating that Manual Punch In/Out
recording Rehearsal mode is entered.