Symbols In This Manual - Ryobi RY72ZTRX76 Manual

Push the joystick forwards to move the
product forward.
Push the joystick backwards to move
the product backward.
Push the joystick diagonally to the
forward left position to make a forward
left turn.
Push the joystick diagonally to the
forward right position to make a forward
right turn.
Pull the joystick diagonally to the
backward left position to make a
reverse right turn.
Pull the joystick diagonally to the
backward right position to make a
reverse left turn.
Push the joystick to the left to perform a
left zero-turn.
Push the joystick to the right to perform
a right zero-turn.

SYMBOLS IN THIS MANUAL

Parts or accessories sold separately
Note
Warning
10
Original Instructions
UNPACKING
See pages 142-143.
■
Remove and set aside all accessible packaging
and wrap from the unit and parts. Do not discard the
packing material until you have carefully inspected and
satisfactorily operated the product.
■
Inspect the product carefully to ensure that no breakage
or damage occurred during shipping.
■
If any parts are damaged or missing, contact an
authorised service centre. Do not assemble the
product until the parts are replaced with new original
manufacturer's parts. Assembling the product with
damaged, missing, or incorrect parts could result in
serious personal injury.
■
If any parts are already assembled to the product when
you unpack it, verify that the part is assembled correctly,
is properly tightened, and is torqued correctly (where
applicable) before proceeding to the next assembly step.
The use of a product that may have been improperly
assembled could result in serious personal injury.
ASSEMBLY
See pages 146-148.
■
The product should be assembled while positioned on
the bottom frame. When assembly is complete, set the
cutting deck to its maximum height, then position a ramp
next to the frame bottom, and slowly and carefully drive
the product off the frame.
■
Strictly adhere to all
specifications. Failure to do so could cause serious
personal injury.
■
To prevent accidental starting that could cause serious
personal injury, always remove the start key from the
product when assembling the parts.
■
Use extra care when driving the product off of the frame.
Press the low speed drive button and carefully move
the joystick and/or press the brake pedal as needed
to control the speed. When driving the product off of
the frame, do not exceed the maximum recommended
operation angle of 12°. Failure to follow these instructions
can result in loss of control and result in death, serious
personal injury, or property damage.
■
If no ramp is available, slowly and carefully drive the
product off the frame in reverse while looking down and
behind. Driving the product off the frame in the forward
direction without a ramp can cause damage to the
cutting deck.
torque wrench tightening