Panasonic WX-C1011 Series Operating Instructions Manual page 12

12
SYSTEM CONNECTIONS AND PREPARATIONS
Caution: The installation described below should be made by qualified service personnel or system installers.
E System Connections
Shown below is an example of a basic system connection.
6 - 15m (20 - 50 feet)
External External
Antenna (Option)
Antenna (Option) Conduit
Center Module
WX-C1011
Speake Menuboard or
d Speaker Post
Vehicle
Detector |
917-1 RU
Conduit
Loop in Pavement
e The distance between microphone and speaker should be approx. 5cm (2 inches) or more.
E Battery Charge and Replacement
Refer to the Operating Instructions provided with the battery charger. The following procedure is a summary of battery replace-
ment and charging.
1. Replace the Battery when the Battery and Power 3. Insert the discharged Battery into the battery compart-
Indicator on the Order Taker blinks and the pulsing ment of the Battery Charger and confirm the RED LED
high/low beep tone is heard in the headset. on the front panel of the Battery Charger lights.
2. Slide the Battery Lock Lever on the Order Taker toward 4. When the Battery is fully charged, the GREEN LED on
the EJECT position and pull out the discharged the front panel of the Battery Charger lights. Use only
Battery. fully-charged batteries.
5. Insert the fully-charged Battery into the battery com-
partment of the Order Taker.
Cautions:
1. Do not shortcircuit between Ф and © terminals of
battery.
2. Read the Battery Charger Instruction Manual com-
pletely for your personal safety and correct opera-
tion.
3. Be sure to charge the battery only after hearing
the high/low beep tone in the headset. Other-wise,
the operating life time may be shortened.
4. Use a fully charged new battery if the battery oper-
Caution: Do eject the battery with care. ating life time has been shortened by incorrect
Otherwise, the battery may be damaged. charging.