Advertisement
OE PLUS SIDE STEPS
07-18 JEEP WRANGLER JK 4-DR
SRJK-08
TOOLS
REQUIRED
- 13mm Socket
- 10mm Wrench/Socket
- 11/32" Drill Bit
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit —
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner's manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
SKILL
LEVEL
- Novice/Intermediate
- 2 persons
Little skill level required, you can
install it by yourself however,
additional help is recommended.
Read and understand all
PRODUCT
INSTALLATION
TIME
- 1.5 Hours.
Time to install this should only
take about an hour and a half.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
NEED HELP?
MANUAL
REQUIRED
855-680-9595
Advertisement
Table of Contents
Related Manuals for DV8 OFFROAD SRJK-08
Summary of Contents for DV8 OFFROAD SRJK-08
- Page 1 1. Name of purchase location Customer Service: 855-680-9595 2. Bar Code on side of box DV8 Offroad is not responsible for any bodily injury or harm to you 3. Date above bar code or your vehicle as a result of an improper install.
- Page 2 INSTALLATION MANUAL Begin by unpacking all items and inspecting for missing pieces or damage. If you have any concerns, please contact the company the product was purchased from. Extra hardware may be included with the product. HARDWARE INCLUDED (6) M8x25 Hex (12) M8 Nuts (6) M8 Flat Washers (Wide) (12) M8 Flat Washers...
- Page 3 INSTALLATION MANUAL STEP 2 | Drill out the front mounting holes on the pinch weld using an 11/32” drill bit. If necessary, step up to a slightly larger drill bit, but for our application an 11/32” drill bit was enough to get our studs through the pinch weld.
- Page 4 INSTALLATION MANUAL STEP 4 | Secure the steps to the pinch welds using the remaining provided M8 hardware with a 10mm wrench/socket. STEP 5 | Congrats! You are finished with the install of the 07-18 Jeep Wrangler JK OE Plus Side Steps. NEED HELP? 855-680-9595...
Need help?
Do you have a question about the SRJK-08 and is the answer not in the manual?
Questions and answers